How To Use Grass Cutter Corn Silage Chopper Grass Chaff Cutter Machine

Working principle of Corn Silage Chopper Grass Chaff Cutter Machine

  When working, the processed forage is linearly fed into the grass cutter roller rotating mechanism under the direct action of the grass feed roller for shredding, and the centrifugal wind generated during the high-speed rotation of the grass cutter roller is used to throw the grass out of the cabinet -5 meters away

The main components of Corn Silage Chopper Grass Chaff Cutter Machine

Including body, frame, grass feed roller, knife holder assembly, fixed blade, movable blade, protective device, etc.

Precautions of Corn Silage Chopper Grass Chaff Cutter Machine

 1. Before using the machine, read the product manual carefully, and adjust and maintain it as required.

2. Before starting the machine, check whether the key components are tight, whether the direction of the cutter wheel is consistent with the specified direction, whether the upper case is tightly locked, and whether the protective cover is installed in place.

3. It is strictly forbidden to open the protective cover when the machine is running.

4. Immediately shut down for inspection if abnormal conditions are found, and it is strictly forbidden to troubleshoot while the machine is running! Remember!

5. When the feeding port is blocked, it is strictly forbidden to feed the material by hand or with a stick to avoid damage to the machine and unnecessary accidents.

6. It is strictly forbidden to mix iron and stones into the materials.

7. The workplace should be ventilated and pay attention to fire prevention.

8. Reasonable selection of power (2.2-4KW is appropriate), and it is not allowed to increase the number of spindles at will.

9. Minors, alcoholics, and people with diseases that affect judgment are not allowed to operate machines.

10. Before normal operation, please run the machine empty for 3-5 minutes to confirm that the machine has no abnormal phenomena before feeding the materials. The feeding must be even and appropriate, and overloading is not suitable.

11. Please pay attention to the warning signs on the machine before starting up, and be careful.

Installation: 

1. Before the machine leaves the factory, it has been installed and debugged, and the user does not need to debug again, just install the body and motor on the bracket.

2. Fasten the main engine and motor on the rack according to the reserved position.

3. Hook the belt, adjust the tightness, tighten the motor, and then power on to run the machine. After confirming that the main shaft rotation direction is consistent with the direction marked on the straw machine, the machine can be tested.