What Causes The Portable Wood Pellet Mill Not To Discharge?

What causes the portable wood pellet mill not to discharge?

1. The moisture content of the material is not suitable. Too much or too little moisture in the material will block the die-hole and cause the portable wood pellet machine to fail to discharge. In this case, check the summed material and control the moisture content between 10%-15%.

2. The mold pressure plate and pressure roller are seriously worn. Die platen and pressure roller are the main accessories of the portable wood pellet mill, and they are also vulnerable accessories. If the accessories are aging or malfunctioning, it is also the reason why the granulator does not produce material. If it is a newly purchased portable wood pellet mill, you only need to see which parts are not working to distinguish which problems. If the granulator has been used for many years, it means that the parts are aging and can be replaced.

3. The mold compression ratio is not suitable. Different materials require different compression ratio molds. The choice of a regular large-scale manufacturer will be customized according to the needs of the customer. Generally, this kind of problem does not occur. If there is no material, check the compression ratio of the mold. If not suitable, replace the material mold.

4. The material has high crude fiber content. Portable wood pellet presses are available in different models and capacities. For different types of granulators, the granulation requirements are also different. Some granulators are suitable for pressing coarse fibers and some are suitable for pressing fine fibers. If you choose a small granulator to press the crude fiber material, it is also the reason why the granulator does not discharge. The solution is to communicate with the manufacturer and replace the granulator.

5. The distance between the mold and the roller is not suitable. Pelletizers facilitate the formation of pellets by squeezing accessory rolls and dies. If the spacing is not suitable, it will also cause the mobile pellet machine to fail to feed normally. The solution is to adjust the spacing.

6. There is accumulated material in the granulator. After the granulator is produced, there will be some deposits, and there will be no clean residue. After the granulator runs next time, due to the high temperature, it will solidify into a hard block, which will cause the granulator to fail to discharge normally. The solution is to clean the inside and clean up the residue.