How To Use The Small Wood Pellet Machine

How to use the small wood pellet machine?

1. Complete the assembly of the equipment according to the manufacturer's equipment manual, and connect the wires correctly according to the instructions.
2. Fill up the grease of the automatic lubricating pump and start the lubricating pump, use the grease to discharge the air in the lubricating pipe until the lubricating oil starts to come out at the end of the oil pipe and stop.
3. Start to feed and grind the prepared oil (quartz sand 15%, sawdust 80%, waste engine oil 5%) evenly. The grinding time of new grinding tools for the first time is controlled at about 30 minutes, and the oil can be used repeatedly.
4. Attention should be paid to the production process, the initial feed amount should be controlled at about 70% of the production capacity, and then as the production continues to be smooth, if there is no die hole blockage, the feed amount can be increased to the normal production level.
5. It is recommended to keep the water content at about 13%, so that the processed particles can achieve their desired effect.
6. Keep feeding at a constant speed, which can ensure the normal operation of the machine and improve the working efficiency of the pellet machine.

When the new machine is tested, it must be fully ground before it can be used in normal production, otherwise
It is very likely that the mold will not be discharged, the machine will be stuck, etc. After the first trial run, in order to increase the service life of the machine,
It is recommended to use the material produced in the first or second test machine to pass through the machine every time before shutting down and starting up, so as to prevent the occurrence of machine blockage.