What Are Common Faults And Solutions Of Pellet Dryer Machine
Oct 02, 2020
1. The dryer material cannot be sucked away:
When the dryer fails to absorb or discharge materials normally, check whether the installation is correct according to the installation drawings, check whether there is air leakage at the pipe interface, and the air leakage caused low wind pressure, and then solve it.
2. The raw materials are not dried at one time:
The dryer is too small, and there are too many raw materials in the dryer; it is also possible that the air pressure and flow calculation of the wind network are not correct; there is another reason that the dryer operator is not familiar with the dryer, resulting in Improper use of the dryer. The dryer can be replaced with a larger capacity; you can also install less each time you load the material; you can also increase the drying temperature, but this method is likely to cause fire in the dryer, the best way is to replace or renew Modify the drying equipment.
3. Drying equipment wastes fuel:
If the insulation of the equipment is poor, the insulation performance needs to be improved, and a layer of insulation material can be wrapped. If there is a problem with the design of the dryer or the design of the dryer furnace, you need to contact the manufacturer to solve it.
4. Uneven material wet and dry:
It may be the improper use of the drying equipment, or the material of the dryer may become agglomerates due to the low temperature. The technical training of the operators should be strengthened to make them proficient in the operation skills; if the raw materials become agglomerates, the drying raw materials need to be broken up and then dried.
