Instructions For Installation And Operation Of Corn Grits Making Machine

Instructions for installation and operation of corn grits making machine

Be sure to pay attention when installing the corn grits-making machine. One of the three live wires and zero wires entering the motor must pass through the galvanometer, and the motor turns in the opposite direction; the V-belt must be tight and loose, not too loose or too tight; Let the device rotate at high speed for three minutes, and pay attention to whether the device vibrates and makes abnormal noises.

The practical operation of the corn grits-making machine

1. Prepare before starting the machine: Wet molting is generally used for corn molting. It is stipulated that the moisture content of the corn entering the machine should be 16-17%, and the moisturizing time should be about ten minutes. Only the outer skin should be wet. Ice is not allowed on the surface of the corn entering the machine. , otherwise, it should cause a stuffy car situation.

2. Operation and shutdown: After the cleaning and operation are all normal, open the feed socket, and control the total flow of raw materials at the feed port according to the driving force load condition. During the whole process of operation, if any abnormal sound is found, it should be shut down and checked first. When the car is stuffy, please turn off the feed socket, rotate the motor wheel slowly and forcefully, remove the corn in the warehouse, and turn it on again.

If you need to buy the corn peeling grits making machine, maize grits making machine, or maize mill machine,  please get in touch with Vincent:

Email:vincent@fandamachinery.com

Whatsapp:008618639007627