Common Problems And Solutions Of Wood Crusher

Common problem solutions for wood crusher machines:

After a long period of use, the wooden powder may occur and may occur. Mechanical problems will affect our normal production. We need to repair the machinery, let's introduce you to the solution to the common problems of wooden powder machines.

If you can easily cause fatigue cracks at the rivet holes, you can use a new welding stick that has not been used for welding and fissure, but you must use the leaf wheel axis line as the center. Stay there, and then use a new box to repair a relatively symmetrical rivet hole crack. After the welding, the remaining box is as long as the remaining electrodes remain during the symmetrical rivet repair to ensure that the weight of the welding is equal. If there is no crack at the symmetrical rivet holes, weld the stack of stacks here to offset the new welding weight of the symmetrical rivet hole cracks. Welding through this symmetrical weight can be used to repair cracks.

Faced with the common problems of the rivet head of the impeller, we can weld with electric welding heaps by compacting the wheels and the impeller body. This method allows the worn rivet head to return to its original normal state.

In fact, the method is also very convenient to perform simple dynamic balance tests on the impeller.
First of all, the impeller should be raised, and then use your hand to rotate it gently. If there is a place where there are heavy places, you can weld it on the opposite impeller to increase the weight to balance it. You can also use the corner mill to remove the welding marks of the impeller, so as to achieve a balance. It's right.

It is very reminded that during the repair process of the fan, you cannot use the welding at will, and leave the welding marks on the impeller, causing the balance of the fans impeller, not to achieve the purpose of repairing the wood powder machine, causing a greater loss of your own losses Essence