There are two reasons why the mechanism charcoal machine breaks the rod during the charcoal-making process:
Aug 28, 2023
There are two reasons why the mechanism charcoal machine breaks the rod during the charcoal-making process:
One: The joint point between the pusher of the briquette charcoal-making machine and the forming sleeve is too large, and the density of the rod body is too loose, resulting in the failure of subsequent materials.
Two: The raw material is too wet and the water content does not reach below 8%, so the stick quality is soft.
It can be seen from the above two points that the phenomenon of broken rods is caused by the density and humidity of raw materials.
Therefore, first of all, you need to determine the moisture content of the raw material after drying through the instrument to ensure that it meets the molding standards before making rods. Secondly, when you choose the mechanism charcoal machine equipment, you must test the machine on the spot, and actually operate it yourself to see whether the mechanism produced by the equipment meets the density and hardness standards.
