Reasons and treatment methods for low output of biomass pellet machine

1. The low output may be caused by improper compression ratio of the biomass pellet machine mold and improper gap between the mold rollers. The compression ratio of the biomass pellet machine mold is determined according to the raw material composition and moisture content of the pressed pellets. The treatment method is to select the appropriate compression ratio of the biomass pellet machine mold after testing and adjust the gap between the mold rollers of the biomass pellet machine.

2. The low output of the biomass pellet machine may be caused by improper moisture content of the raw materials. The treatment method is to adjust the moisture content of the raw materials. The moisture content of raw materials such as sawdust required for pressing biomass pellets is about 10-15%. Too high or too low will reduce the output.

3. The low output of the biomass pellet machine may be caused by the fact that the biomass pellet machine mold is not ground or ground improperly. The inner hole of the new mold of the biomass pellet machine may have burrs due to heat treatment, which affects the output. The treatment method is to repeatedly extrude the mixture of engine oil, sand and sawdust according to the formula provided by the original manufacturer of the biomass pellet machine.

4. The low output may be caused by untimely wear and maintenance of the biomass pellet machine. The mold and roller of the biomass pellet machine will wear out after a long time of use, which is inevitable. Do a good job of machine maintenance and replace and maintain it in time.

The reasons and treatment methods for low output of biomass pellet machine, wood chip pellet machine, sawdust pellet machine, fuel pellet machine, and bark pellet machine are basically included above.