How to operate a wood shredder

How to operate a wood shredder？

1. The wood shredder should be fixed on the ground and can be fixed with cement.
2. Before the wood shredder works, it is necessary to carry out a test machine before starting the machine, which is to simply turn the main shaft to see if the bearing is operating normally. Before installation, check whether the gap between the parts is firm and whether the foundation is stable. It is a waste of time and a waste of materials to reinstall the wood shredder after finalizing the shape;
3. The pulverizer and motor should be installed on the base made of angle steel.
4. When the wood flour machine starts to operate, pay attention to whether there are sundries on the wood grinder machine. When the wood grinder is tested, check whether it is reversed. Put in fewer materials to see if the finished product is up to standard. Wood grinder customers buy After returning home, when installing and testing the machine, try to wait for the previous piece of wood to enter the feed port before putting in the second piece of wood to avoid machine jamming.
5. The feeding of the wood shredder should be uniform. If there is noise, excessive temperature of the bearing and the body, outward spraying, etc., it should be stopped immediately for inspection and troubleshooting.
6. The circuit inspection should be done before starting and shutting down the wood crusher to avoid leakage. The length of the wood must be moderate, not too long, preferably under 30 cm, and not too thick. The area around the outlet and inlet should be as spacious as possible to avoid some accidents.
7. After 300 hours of operation, the bearing must be cleaned and the engine oil replaced; when installing the engine oil, it is better to fill the gap of 1/3 of the bearing seat, and no more than 1/2. When stopping for a long time, the transmission belt should be removed.
8. The wood shredder stops feeding before shutting down, and after the materials in the standby are removed, cut off the power and stop. Cleaning and maintenance should be carried out after shutdown.
9. The staff should carefully check the materials before the wood crusher works to prevent hard objects such as metals and stones from entering the crushing room and causing accidents.
10. Do not change the pulley frequently to prevent the speed from being too high or too low.