Precautions For The Use Of Feed Pellets Press Machine

Precautions for the use of feed pellets press machine:

1. For secondary use of new machines, it must be used for running in or not.

2. Lighting power supply, copper wires with a power cord of not less than 4 square meters, and the instrument is 5-10A.

3. When working, do not reach into the feed mouth when working.

4. Before the machine is turned on, you must add less feed and then boot. Leave a little feed in the machine when shutting down to prevent the machine's pressure rollers from contacting the template.

5. If there is a stuck in the machine work, it should be stopped immediately. After the pressure roller is compacting the bolts, the machine should be restarted.

6. Every time you work, you must loosen the adjustment of the pressure roller bolt.

7. After the machine uses a certain amount of time or press a certain amount of particles, if the granular material is made into a broken end or the particles are not true, the grinding plate should be turned to the mixed feed to add 2%-4%of water.

8. Regularly check the tightening of the belt to prevent the production of the machine low, the belt slipping, etc.

9. When the particle machine is used again, it should work lowly for about 40 hours, and then replace the gear oil in the gearbox. In the future, it takes 100 hours to replace it regularly, and all bearings must be injected regularly. 10. The particle machine continuously works, and the electric motor is hot to 70 degrees, which is a normal phenomenon.