Why should the transmission parts of the wood powder pellet machine be refueled regularly?

Why should the transmission parts of the wood powder pellet machine be refueled regularly?

1. When using the wood powder pellet machine, you must carefully check whether the connecting parts of each part are loose and whether the travel safety switch is reliable once a week. At the same time, clean the feeding auger and conditioner to avoid mechanical failure.

2. Check the wear of the transmission key, die lines, and clamp every half month. If wear is found, replace them in time to avoid the ring die shaking and affecting the output.

3. Use high-quality ring dies and rollers. Do not use inferior ring dies with out-of-round and rough inner holes, and select the compression ratio of the ring die according to different formulas to ensure smooth discharge of the ring die, avoid increasing power consumption, and reduce production capacity.

4. We also need to refuel the transmission parts of the wood powder pellet machine regularly, lubricate the roller bearings every 2 hours, and lubricate the front bearings of the main shaft every 4 hours to ensure the flexible rotation of the transmission parts of the wood powder pellet machine and reduce the workload.

5. Regularly replace the lubricating oil in the gearbox of the wood powder pellet machine. The oil needs to be replaced after the new machine has been running for half a month, and then it must be replaced every 1000 hours of continuous work, which can extend the service life of the gear.