What is the cause of the slip of the pellet machine bearing

What is the cause of the slip of the pellet making machine bearing?

When the bearing slips in the use of the pellet machine, it will not only affect the grain output, but also seriously affect the grain output. Therefore, this issue must be paid attention to in time to ensure production efficiency and equipment quality. What are the reasons for slippage? Here are the reasons and how to deal with them.

 1. The bearing installation of the pellet machine is not flexible enough, causing the shaft to slip.

　　When installing the pressure roller, do not install the bearing too hard, otherwise it will cause the slip problem in the pelletizing operation of the pellet machine.

　　The solution to this problem is to always pay attention to the final axis of the pressure roller, even if the pressure roller is replaced with a new one.

2. Excessive moisture in granular raw materials will affect the loss of points in the finale.

　　 When the raw material is pressed with a pellet machine, the water content of the raw material is too large or the steam generated when passing through the equipment is too large, which will cause the equipment bearing to slide due to the lubrication of water that acts during the material manufacturing operation of the equipment.

　　The way to solve this problem is to reduce the steam inflow of the raw materials and keep the moisture in the raw materials within a reasonable range.

3. The pellet machine finale is too big to clear the finale.

　　 When using the equipment to operate, if the equipment bearing clearance is not well controlled, it is easy to see that the particles produced during the granulation process are not uniform enough, the output is too small, the equipment pressure roller can not press the material tightly, and the bearing is easy to slip.

　　The solution to this problem is to shorten the distance between the two main axes of the equipment.

　　 4. Excessive use of pellet machine bearings will affect the sliding of the bearings.

　　When the equipment is used for a long time, it will cause the final shaft to wear out (the basic type of component failure), which will cause the final shaft to slip and make it unable to work normally.

　　A good way to solve the slip of the pellet machine is not only to keep the equipment clean from time to time, but also to replace it with new bearings at any time.

If you need pellet making machine , please contact:

Vincent:whatsapp:008618639007627

Email:vincent@fandamachinery.com