The shutdown sequence of wood pellets is opposite to the startup

The shutdown sequence of the wood pellets is opposite to the startup, and the related equipment is turned off from front to back according to the process flow. When the low position locator of the grain storage box does not display any material, open the manual feed door of the wood pellet machine and observe the flow state of the entrance. When the flow rate is significantly reduced, manually discharge the cooler to increase the flow rate of the machine, increase the flow rate of the feed port of the granulator, and ensure the granulation quality. At this time, you need to pay attention to whether the return pipe is blocked. If the return pipe is blocked, manually remove the cooler and turn the machine back. If the return pipe is not blocked, please wait for the feed inlet to observe. After completing the material in the return pipe, wait a few minutes, and then release the material into the cooler, so that there is only a small amount of recycled material in the return pipe, which can reduce the pollution of the next production. The newly purchased wood pellet machine template needs to be run-in, so the new machine needs to use added fat feed (5 kg feed, 1.5 kg fine sand, 2 kg) engine oil, no need to add water), in general, the feed moisture should be controlled within Between 4-6%. Adjust the gap between the pressure roller and the template to be about 1 mm. After adjusting the pressure roller, tighten the fixing bolts. (If the template is blocked, you need to check the knife edge and the filter with a hand drill and refill it. The gap between the knife edge and the filter should be suitable for the reverse rotation of the sawdust machine. The motor reverse rotation can be careful! Sometimes the output ends, sometimes no output, This usually has nothing to do with the positive or negative rotation of the motor. Whether it is good or bad, it is related to the aging degree of the wood pellet machine template. For wood pellet machines, refueling is an unavoidable operation. This is for the maintenance of wood pellet machine Maintenance and maintenance are very important. However, there is a way to follow up and refuel. If you can’t think of it, you can carry out the refueling operation. The wood pellet machine should be refueled according to five items. Regularly: Refuel, refuel and clean according to the cycle specified by the lubrication card.