Reasons for blockage of small wood pellet machine

Reasons for blockage of small wood pellet machine:
1. The adhesion of raw materials. If raw materials with poor adhesion are selected during production, the produced particles will not be ideal, and the particles with good effect can be produced only when the thickness is matched.
2. Raw material moisture requirements. If the moisture contained in the raw material is large, the granules will not form; if the moisture is too small, it will be difficult to be pressed together to form granules. Generally, we require that during the granulation process, the moisture content of the feed material should not exceed 12%. If the material is too dry, auxiliary equipment such as a conditioner can be used.
3. Raw material size requirements. The raw material for making granules is recommended to be about 3mm. Taking straw as an example, when the crushed straw is too large, it will affect the hourly production of granules. During production, always pay attention to whether the feeding port and the screen of the flat-die granulator are in good condition. blocked.
4. Before production, run through the flat-die granulator with oil to ensure lubrication. Before finishing the granulation work, also use oil to run through the flat-die granulator to prevent clogging of the die holes.
5. If the voltage is too low, it may also cause the output of the feed pellet machine. Generally, farmers are located in remote areas with a certain distance from the village, and the voltage used may be unstable. Therefore, if the above possibilities are ruled out, the system can be used when the peak period of electricity consumption is not. Check the effect of the granulation. If the feeding is slow and the granulation speed is fast, it can be adjusted appropriately.
6. The material of the flat mold plate. The flat mold plate of the treasure shell brand is made of Xp46Cr13 stainless steel, which is completely imported from Italy with gun drilling and advanced vacuum heat treatment technology to avoid the oxidation of the mold hole, effectively ensuring the smoothness of the mold hole, and its hardness and wear resistance surpass similar products in the market.