How to operate the sawdust pellet machine correctly

How to operate the sawdust pellet machine correctly？

During the use of the sawdust pellet machine, in order to ensure safe production, and to improve the equipment's production rate of finished products. In the maintenance of equipment, it is necessary to reduce mechanical wear, reduce mechanical operation and maintenance costs, and ensure that the machinery is in good condition.

　　 1. Pellet machine equipment should follow the principle of "equal attention to maintenance and prevention first", and regular and mandatory maintenance work is not allowed.

　　2. Good lubrication is the main method to avoid and delay the wear of parts. Lubrication treatment is the most basic and most important link in the maintenance of mechanical equipment. Good lubrication of equipment can not only reduce physical wear and extend equipment life but also has important meaning to the company's economic benefits.

      3. The cleaning of dust has a positive effect on the normal operation of the sawdust pellet machine. Regular dust cleaning can not only make the equipment look neat and beautiful, but also benefit the good heat dissipation of the equipment and prolong the service life of the equipment. For electrical equipment, It can also avoid short circuits caused by excessive dust.

　　4. During the operation of the sawdust pellet machine, various parameters such as temperature, pressure, liquid level, vibration, etc. must be accurately recorded in order to observe the operating status of the equipment.

   Before starting the sawdust pellet machine, it is necessary to confirm the storage of the silo and the residual condition of each process, understand the status of the pellet machine and production plan, turn on the steam drain switch, and let off the condensed water in the steam for about two minutes to start the machine. It can be smoother. Here is an introduction to the start-up process of the pellet machine.

   1. When the host button on the electric control cabinet is pressed, the pellet machine will start to run, but at this time, the pellet machine has not really started up, and it cannot be pelletized or added to the oil to wash the mold.

   2. After the pellet machine is delayed to start after the ammeter shows that the current is normal, you should put in some oily materials first, and rinse the ring mold for about one minute, so that it is very necessary to heat the ring mold.

   3. At the beginning of feeding, the feeding amount should not exceed 20% of the production capacity of the pellet machine at most to prevent the pellet machine from feeding too much material in an instant, and the load suddenly increases, causing machine blockage or mechanical damage.

   4. When the material has been quenched and tempered, it feels tight and can form a mass, and when it can disperse after letting go, close the feed door and press it.

Zhengzhou Fanda Machinery Co., Ltd. can provide all kinds of pellets machines, such as wood pellet mills, biomass pellet making machines, animal pellet making machines, biomass pellet production line, and so on. The machine has good quality and stable performance and long service life.

Vincent:whatsapp:008618639007627

Email:vincent@fandamachinery.com