The working principle of the straw shreder and kneading machine

Silage guillotine kneading machine, automatic feeding, and automatic cutting to length are used in cattle and sheep farms. The silage guillotine kneading machine has an additional function of kneading silk on the basis of the guillotine machine. Kneading silk can rub the grass, grass straw, etc. very finely so that the straw is very soft, the animals eat it, the palatability is better, and the feed intake is increased. For cattle and sheep farms, chickens, ducks and goose breeding, pig farms, rabbit farms, etc.

When the silage guillotine kneading machine is used, it is connected to the electricity, the small one uses two-phase electricity, and the large one uses three-phase electricity. Then you can put corn stalks, wheat stalks, imperial bamboo grass, silage, pasture, elephant grass or sweet potato seedlings, peanut seedlings, etc. on the conveyor belt, and the automatic feeding can start to cut and knead. The output forage can be directly fed or sprayed into the baler for baling, or stored for use as feed pellets, etc. can be fed to animals. That is, increasing nutrition saves money.

The silage guillotine kneading machine adopts widened and thickened manganese steel knives, high-quality steel, wear-resistant, and long service life. Automatic feeding, chain-disk feeding, widening and thickening, fast feeding, and high production efficiency. Thickened hot wheel cutter plate, fast crushing speed, no sticking, dry and wet dual use, the length of the shredded grass can be adjusted, 1.5-3.5 cm. Adjustable speed gearbox, precise adjustment. Double straw design, automatic feeding saves time and effort. The height of the discharge port can also be adjusted, the feeding is smooth, and the discharge is convenient. The angle of the discharge port can be adjusted according to the production needs to meet the production requirements and save manpower and material resources. There are moving wheels at the bottom for easy movement. It is very easy to push.

The silage guillotine kneading machine is powered by a motor. The power is transmitted to the main shaft, and the gear at the other end of the main shaft transmits the speed-regulated power to the pressing grass run through the gearbox, universal joint, etc. And it is sent into the guillotine cutting mechanism at a certain speed, and after being chopped by a high-speed rotating knife, it is thrown out of the machine through the grass outlet.