The operating Instructions of the wood crusher

The operating instructions of the wood crusher machine :

1. The wood crusher should be fixed on the ground and can be fixed with cement.
2. The wood crusher should perform the test machine before working. It is to simply rotate the main shaft to see if the bearings run normally, check whether the gap between the parts before installation and check whether the foundation is stable because the installation is basically installed because it is basically installed. Format, it is a waste of time to reinstall the wood crusher, which is also a waste of materials;
3. The pieces and the motor should be installed on the seats made of angle steel.
4. When the wood powder machine starts operation, pay attention to whether there is debris on the wood crushing machine. When the wood crushing machine tests the machine, to see if it is inverted, fewer materials are put in to see if the processing of the processed After returning home, when the test machine is installed, try to wait as much as possible when you put the wood as much as possible to enter the feed inlet and then put it in the second piece to avoid the case of the card machine.
5. The feeding machine should be delivered evenly. If there is a phenomenon such as miscellaneous sounds, bearing and the temperature of the body, or an outward spray, it should be immediately stopped to check to eliminate the failure.
6. Circuit inspections must be performed before turning on and shutting down from the wood shatter to avoid leakage. The length of the wood must be moderate, not too long, the best, or too thick below 30 cm. The material outlets and feed inlets are as spacious as possible to avoid some accidents.
7. After 300 hours of operation, the wood crusher must be cleaned and replaced with engine oil. When installing the oil, it is better to use 1/3 of the gap of the bearing seat, and it must not exceed 1/2. When shopping for a long time, you should remove the transmission band.
8. The wood crusher stops the feeding before the stop. After the material in the standby is cleaned, cut off the power to stop. After stopping, clean and maintain.
9. Before working, the staff should check the materials carefully to prevent hard objects such as metals and stones from entering the crushing room.
10. Do not change the wheels often to prevent too high or too low speed.