How to use the pellet machine correctly？

How to reduce the failure rate of pellet machine during operation：

1. The pellet machine should be placed in a dry room for use, and should not be used in places where the atmosphere contains corrosive gases such as acids.

2. Regularly check the machine parts to see if they are working properly. Check once a month. The inspection includes whether the worm gear, worm, bolts on the lubricating block, bearings and other active parts are flexible and wear-resistant. If defects are found, they should be repaired in time and no longer used.

3. After the pellet machine is used or stopped, the rotating drum should be taken out for cleaning and brushing the remaining powder in the bucket (only for some feed pellet machines), and then installed properly to prepare for the next use.

4. When the drum moves back and forth during operation, the M10 screw on the front bearing should be adjusted to the appropriate position. If the gear shaft moves, please adjust the M10 screw behind the bearing frame to the appropriate position, adjust the gap so that the bearing does not make noise, turn the pulley by hand, and it is better to be loose and tight. If it is too tight or too loose, the machine may be damaged. 5. If the machine is not used for a long time, the whole unit must be cleaned and the smooth surface of the machine must be coated with anti-rust oil and covered with a cloth.