How to operate the feed pellet machine

   First, in order to avoid accidents in the transportation, loading and unloading of the feed pellet  machine, it is necessary to check whether the bolts and nuts in each part are loose before use, and whether the flat teeth, round teeth and spindle nuts are loose, and tighten them in time. Then turn the pulley by hand to check whether the machine collides. At the same time, pay attention to check whether the equipment can maintain flexible operation. If there is debris in the machine, it must be cleaned up. It is generally required to run the equipment dry for a while to confirm that there are no abnormal problems before normal production can begin.

    Second, in the process of operating the feed pellet machine, we must pay attention to strictly control the cleanliness of the materials. If there are sundries in the materials, they must be cleaned up. It is strictly forbidden to enter the machine to avoid damage to the machine. In addition, the receiving cloth bag should have a length of more than 4 meters and a diameter of 0.6 meters. The fabric should not be too dense. The material should be discharged in time to ensure that the bag has sufficient air permeability.

    Third, during the operation of the feed pellet machine, it is necessary to strictly control the feeding. It should be noted that the feeding should be kept uniform, and the degree of power load should be paid attention to to avoid choking. When smashing particles, the feed amount of the pumping plate regulator section can be used. It should be noted that when a corner wear affects the work efficiency, the reverse side of the hammer can be turned (4 groups at a time when turning, so as not to cause the rotor imbalance) replacement hammers should be replaced all.

    In addition, before using the feed pellet machine every day, the lubrication should be checked, and the appropriate amount of lubricant should be added in advance, and the bearing condition should be checked after 500 hours of use. When installing the screen, the burr side should be installed on it. According to the fineness of the crushed materials, sieve pieces of different diameters are selected. In addition, the reasonable design and parameter selection of feed machinery must also be reasonable.