Causes And Solutions For Wood Crusher Leakage

Causes and solutions for wood crusher leakage:

After a long period of high-intensity production work, the wood crusher will inevitably lead to aging on the surface of some internal components. Therefore, in order to ensure that the wood crusher equipment can carry out production operations smoothly and stably in the later stage, we need to use wood crushing in the operation. The corresponding daily maintenance work has been done when the machine equipment is used. What we are going to talk about today is the leakage problem of the wood crusher equipment. Some users may have encountered this problem but they don’t know what caused it and they don’t know the correct way and solution.

First of all, we should do a good job of inspection before operating and using the wood crusher equipment to see if the power cord has oxygen, falling off, or breaking. If there is no such phenomenon, you can plug in the power supply and test the machine. You can rotate the wheel after turning it by hand. In this case, it can be judged that it is caused by a failure in the starting capacitor. Replace the new capacitor to solve the problem; The sound of the current is heard, which is caused by the leakage of the starting capacitor. If the current sound is very loud and the wood crusher motor cannot be started, it can be judged that the problem is caused by a short circuit of the starting capacitor. The short circuit of the motor coil needs professional repair. Pull the two lead wires out of the zero and front jacks of the mains respectively to charge the capacitor, and then remove the two lead wires to short-circuit and discharge them. If the discharge spark can be produced at this time and there is a loud "pop" sound, it means that the capacitor can be used; if the spark and sound are weak, it means that the capacity of the capacitor has decreased, and it needs to be replaced or a small capacitor can be added.