Operation steps of corn peeling and grits making machine

Operation steps of corn peeling and grits making machine:

When installing, it must be noted that one of the three live wires entering the motor must pass through the ammeter, and the motor wheel turns counterclockwise; the V-belt must be tight, not too loose or too tight; after the installation, let the machine idle for two minutes, pay attention to the machine Whether there is vibration and abnormal sound.

Operation

1. Preparation before starting the machine: Wet peeling is generally used for corn peeling. The water content of the corn entering the machine is required to reach 16-17%, and the moisturizing time is about 10 minutes. Only moisten the lower epidermis, and it is strictly forbidden to have water on the surface of the corn entering the machine. , otherwise, the car stuffy phenomenon should occur.

2. Running and stopping: After starting the machine and running normally, open the feeding insert, and control the material flow at the feeding port according to the power load. During operation, if any abnormal sound is found, it should be stopped immediately for an inspection. When the car is stuffy, the feeder should be closed, the motor wheel should be slowly turned by hand to remove the corn in the cabin, and the machine should be turned on again.