The influence of raw materials on the working efficiency of straw pellet machine

The influence of raw materials on the working efficiency of straw pellet machine：

During the production and processing of straw pellet machines, the raw materials have a great impact on the efficiency. If the quality of the raw materials is not high, it will have a great impact on the efficiency of the straw pellet machine and affect its feeding effect. So what is the impact of the raw materials on the efficiency of the straw pellet machine?

1. Viscosity of the material: The greater the viscosity of the common material, the easier it is to adhere. The viscosity of the raw material adheres in the granulation chamber. If it is not cleaned in time, it will seriously affect its efficiency and normal operation.

2. Material composition: The particle size of the common material is reduced, and granulation and the size of the material is reduced. Because the size of this material is small, the mold that is easy to press into holes should be processed in the front stage of the material as much as possible, and the roughage should be selected from the material as much as possible, so as not to affect the normal operation of the equipment.

3. Material strength: It is more difficult to granulate hard materials. The required forming pressure is too large. The more serious the damage to the equipment, the slower the efficiency and the smaller the granulation capacity.

4. Moisture content of materials: The higher the water content, the worse the granulation of the raw materials, and the lower the water content, the better the treatment. If the water content is too low, it will cause excessive energy consumption, excessive material density, damage, and tearing, which depends on the actual requirements of the wood used.

According to the above introduction, we can understand that the viscosity, composition, strength, moisture content, and other factors of the straw pellet machine's raw materials may have a certain impact on its efficiency. Therefore, in the subsequent operation of the equipment, we must pay attention to the proper regular inspection and treatment of the raw materials. Only by ensuring its compliance rate can we ensure the quality of its production.