Causes Of Abnormal Noise And Vibration When The Pellet Machine Is Running

Causes of abnormal noise and vibration when the pellet machine is running

     If it is because of unstable raw material conveying, the feeding speed should be adjusted;

　 If the deflection scraper wears and causes uneven feeding, then a new scraper should be replaced;

　 If it is caused by the problem of the old and new combination of the ring die and the pressure roller of the pellet machine, it is best to match the new ring die with the new pressure roller;

　 If the gap between the ring die and the pressure roller is not compatible with the material produced, then adjust the pressure roller gap;

　 If the formula used is more difficult to granulate, adjust the formula appropriately;

　 If the steam supply is insufficient or the pressure changes from time to time, then check whether the steam pipeline and system pressure and pressure reducing valve are normal

　 If it is because there is debris in the pelletizing bin, then remove the debris in the pelletizing bin

　 If the spindle bearing is worn or damaged, the bearing needs to be replaced.

  After the wood pellet machine works normally, prevent the wood with metal, brick, and stone from entering the machine; after all the materials and the machine work without any doubt, start feeding, and the feeding should be uniform and stable so that the power can be used. It also prevents the appearance of jams. Regarding the smoothness of the equipment, the smoothing and refueling time must be issued according to the processing frequency, so as to make the product life longer and very good processing and production. Under normal circumstances, the main engine grinding bearings add molybdenum disulfide lithium-based grease once every 12 hours, the cause of abnormal noise and vibration during the operation of the pellet machine.

  　The fineness of sawdust can be adjusted according to the position of the regulating valve, and the fineness of the product should be checked in time. The amount of finely ground material in the sawdust pellet machine will affect the flour milling, and the adhesion will affect the looseness. The wood flour must be sieved early, and too large particles will also affect the output value. The wood pellet machine can produce wood, pinewood, miscellaneous wood, poplar wood, fir, raw bamboo, bamboo, and other woods, and it can also be used for fibrous stalk-like materials such as thatch, straw, corn stalk, sorghum stalk, etc.